Table of Contents
Advertisement
Operator's Manual
Operating Instructions
CHANGING THE ATTACHMENT
CAUTION
Use only attachments directly manufactured or
recommended by Terexlift and detailed in the
"Optional Attachments" section.
Version with MECHANICAL LOCKING
To change an attachment, operate as follows:
•
Drive to the place where you will release
the mounted attachment (when possible, a solid and
sheltered site).
•
Disconnect the quick connectors of the
attachment (if any).
•
Pull out pin 1 locking the attachment after
removing the safety split-pin 2 at its end.
•
Rest the attachment flat on the ground.
•
Pitch the attachment holding frame forward
and lower the boom to release the attachment upper
lock.
•
Move back with the machine and drive to
the new attachment to be coupled.
•
Hold the frame pitched forward and hook
the upper lock of the new attachment.
•
Retract and raise the attachment some
centimetres. It will centre automatically on the quick
coupling frame.
•
Refit pin 1 fixing it with its safety split-pin 2.
•
Re-couple the connectors of the attachment
(if any).
88
GTH-4013 SX - GTH-4017 SX - GTH-4013 EX - GTH-4017 EX
First Edition - Second Printing
WARNING
After substitution, visually check the attachment
is correctly coupled to the boom, before operating
the machine. A wrongly coupled attachment may
result in damage to persons or things.
Part No. 57.0009.0540
Courtesy of Crane.Market
Advertisement
Table of Contents
