Maintenance Interventions - Genie GTH-4013 SX Operator's Manual

Operator's Manual
Maintenance

MAINTENANCE INTERVENTIONS

WARNING
All maintenance interventions must be carried
out with engine stopped, parking brake engaged,
working attachments fl at on the ground and gear
lever in neutral.
WARNING
When raising a component for maintenance
purposes, secure it in a safe way before any
maintenance intervention.
WARNING
Any intervention on the hydraulic circuit must
be carried out by skilled personnel.
The hydraulic circuit of this machine is fi tted
with pressure accumulators. You and others
could be seriously injured if accumulators are
not completely depressurised.
For this purpose, shut the engine down and step
on the brake pedal 8/10 times.
WARNING
Before any operation on hydraulic lines or
components, make sure there is no residual
pressure. For this purpose, stop the engine,
engage the parking brake and operate the
control levers of the main valve in both working
directions (alternately) to depressurise the
hydraulic circuit.
102 GTH-4013 SX - GTH-4017 SX - GTH-4013 EX - GTH-4017 EX
First Edition - Second Printing
CAU T I ON
High pressure lines must be replaced by qualifi ed
personnel only.
Any foreign matters entering the closed circuit
may result in a sudden deterioration of the
transmission.
CAU T I ON
The qualifi ed staff charged with the maintenance
of the hydraulic circuit must clean all areas
around with care before any intervention.
PROT ECT T H E
EN V I RON M EN T
The handling and disposing of used oils can be
ruled by local or national regulations. Address
to authorised centres.
NOTICE
During maintenance or repair works, and while
welding, turn off the disconnected battery
switch, located into the engine compartment
below the engine air fi lter.
Part No. 57.0009.0540
Courtesy of Crane.Market