Table of Contents
Advertisement
First Edition - Second Printing
Adjusting the seat
Position the seat so you can comfotarbly reach all
the controls. The handler seat is fitted with devices
which let you adjust the seat springing, height and
distance from the controls, the backrest angle and
the armrest height.
•
Adjusting the seat distance from the controls
To slide the seat forward or back, rotate lever
A and push the seat to the desired direction. Then
release the bar and make sure that the seat locks in
position.
•
Adjusting seat height and springing
Free the lever of knob B and turn clockwise
or counter-clockwise until reaching the desired
springing. Once you'are correctly seated in the seat
check that the yellow indicator C is in the green field.
•
Adjusting the backrest angle
Operate lever D, press your back firmly
against the backrest and put the backrest at the
angle you wish, then release the lever.
•
Adjusting the armrest height
Raise armrest E and turn wheel F to put the
armrest at the height you want.
CAUTION
•
The seat is for one person only.
•
Don't adjust the seat when the machine is
moving.
Part No. 57.0009.0540
GTH-4013 SX - GTH-4017 SX - GTH-4013 EX - GTH-4017 EX
Operating Instructions
Fastening the seat belts
Sit correctly in the driving seat; then:
•
The safety belts are equipped with reel
retractor. To fasten the belt, pull tab 1 and push it
into buckle 2.
•
To release the belt, push button 3 and
remove the tab from the buckle.
•
Make sure that the buckle is correctly located
at the hip point and not on the stomach.
•
Operate the end adjusters to reach the
length you wish and make sure the buckle is always
in the middle.
3
2
DANGER
Not fasting the seat belts could result in death
or serious injury.
Operator's Manual
1
77
Courtesy of Crane.Market
Advertisement
Table of Contents
