Table of Contents
Advertisement
First Edition - Second Printing
WARNING
Make sure the machine (wheels and stabilisers)
rests on a firm ground to prevent hazardous unstable
conditions.
If the ground is not firm enough, position some
supporting planks under the stabilisers or the
wheels.
•
Look for the best route to the job site.
•
When the machine is running, nobody can enter
its working range.
•
While working, keep the working area in order.
Never leave objects scattered: they could hinder
the machine movements and represent a danger
for personnel.
•
In presence of trenches, lower the outriggers at
a safe distance from the trench edge.
A
A ≥ B
Part No. 57.0009.0540
B
GTH-4013 SX - GTH-4017 SX - GTH-4013 EX - GTH-4017 EX
Safety Precautions
OPERATION OR MAINTENANCE HAZARDS
Before any operation, following precautions should
be taken:
•
First of all, make sure that the maintenance
interventions have been carried out with care
according to the established schedule.
WARNING
Set the machine to working configuration and sway
it. Use the special inclinometer to the right of the
driving place to check that the machine is level
before operating it.
•
Ensure you have enough fuel to avoid a sudden
stop of the engine, especially during a crucial
manoeuvre.
•
Clean instruments, data plates, lights and the
cab windscreen thoroughly.
•
Check the correct functioning of all the safety
devices installed on the machine and in the job
site.
•
In case of troubles or difficulties, inform the
foreman at once. Never start working under
unsafe conditions.
•
Do not carry out any repair work in a makeshift
way to start working!
During work, and especially maintenance, always
pay the greatest attention:
•
Do not walk or stop under raised loads or
machine parts supported by hydraulic cylinders
or ropes only.
•
Keep the machine handholds and access steps
always clean from oil, grease or dirt to prevent
falls or slips.
Operator's Manual
31
Courtesy of Crane.Market
Advertisement
Table of Contents
