Test The Road Lights; Workplace Inspection - Genie GTH-4013 SX Operator's Manual

First Edition - Second Printing
35 Raise the boom over 20° and extend it.
Result: The sway function and the outriggers
should not work.

Test the Road Lights

36 Verify that all lights are functional.
Part No. 57.0009.0540 GTH-4013 SX - GTH-4017 SX - GTH-4013 EX - GTH-4017 EX

WORKPLACE INSPECTION

The workplace inspection helps the operator
determine if the workplace is suitable for safe machine
operation. It should be performed by the operator
prior to moving the machine to the workplace.
Make sure:
You learn and practice the principles of safe
machine operation contained in this operator's
manual.
1 Avoid hazardous situations.
2 Always perform a pre-operation
inspection.
3 Always perform function tests prior to use.
4 Inspect the workplace.
5 Only use the machine as it was intended.
It is the operator's responsibility to read and remember
the workplace hazards, then watch for and avoid them
while moving, setting up and operating the machine
Be aware of and avoid the following hazardous
situations:
• drop-offs or holes
• bumps, floor obstructions or debris
• sloped surfaces
• unstable or slippery surfaces
• overhead obstructions and high voltage
conductors
• hazardous locations
• inadequate surface support to withstand all load
forces imposed by the machine
• wind and weather conditions
• the presence of unauthorized personnel
• other possible unsafe conditions
Operator's Manual
Inspections
73
Courtesy of Crane.Market