Genie GTH-4013 SX Operator's Manual page 100

Operator's Manual
Maintenance
5. Check the air suction hose between engine and
filter.
6. Check the cylinder chromium-plated rods.
7. Check the hydraulic lines are not worn because
of rubbing against the frame or other mechanical
components.
8. Check the electric cables do not rub against the
frame or other mechanical components.
9.  Check the wear of the sliding pads of the
boom sections.
10.  Adjust the play of the sliding pads of the boom
sections.
11. Remove any grease from the boom, then re-
grease the sliding parts of the boom sections.
12. Check the level of the battery electrolyte.
Every 3 working months
Jobs to be done in addition to those above
1. Check the efficiency of the block
Every 500 working hours or every six months
Jobs to be done in addition to those above
1. Visually check the smoke quantity evacuated
from the engine exhaust.
2. Check the tightening of the engine fixing screws.
3. Check the tightening of the cab fixing screws.
4. Check the backlash between pins and bushings
in all joints.
5. Change the hydraulic oil filter in the tank.
6. Have the hydraulic system checked by a skilled
technician.
7. Change the main cartridge of the engine air filter.
8. Renew the cartridge of the engine oil filter and
the fuel filter.
9. Change the oil of the front and rear differential
casings.
10. Proceed with boom chain tensioning.
100 GTH-4013 SX - GTH-4017 SX - GTH-4013 EX - GTH-4017 EX
Every 500 working hours or yearly
Jobs to be done in addition to those above
1. Change the engine oil and renew the fuel filter.
Every 1000 working hours or yearly
Jobs to be done in addition to those above
1. Change the safety element of engine air filter.
2. Change the oil in the power divider gearbox.
3. Change the oil in the four wheel reduction gears.
4. Change the hydraulic oil.
Every 2000 working hours or every two years
Jobs to be done in addition to those above
1. Change the engine coolant.
At 6000 hours or 5 years and, subsequently,
every 2 years
Jobs to be done in addition to those above
valves.
1. Check that the structure is intact paying a special
attention to the welded supporting joints and the
boom pins.
First Edition - Second Printing
Part No. 57.0009.0540
Courtesy of Crane.Market