Greasing - Genie GTH-4013 SX Operator's Manual

First Edition - Second Printing

GREASING

CAU T I ON
Before injecting grease into the greasers,
thoroughly clean them to avoid that mud, dust
or other matters can mix with the lubricant and
reduce or annihilate the lubrication effect.
Remove any old grease with a degreaser from
the telescopes before smearing them with new
grease.
Regularly grease the machine to grant it efficient
conditions and a long life.
By means of a pump, inject grease into the special
greasers.
As the fresh grease comes out, stop the operation.
The greasing points are shown in the following figures:
- the symbol represents the points to be
greased by a pump
- the symbol represents the points to be
greased by a brush.
SERVICE INTERVAL
Running-in __________________________ None
Ordinary __________________ Every
Part No. 57.0009.0540
10
hours
GTH-4013 SX - GTH-4017 SX - GTH-4013 EX - GTH-4017 EX
CAU T I ON
Use only PTFE INTERFLON FIN GREASE LS 2
to lubricate the sliding parts of the telescopic
section. Observe the following schedule:
• After the fi rst 50 operating hours (1 week)
• After the fi rst 250 operating hours (1 month)
• Every 1000 operating hours (6 months)
Remove any old grease from the boom and
smear the sliding area of the blocks with a thin
coat of grease.
Operator's Manual
Maintenance
111
Courtesy of Crane.Market