Ordinary Maintenance - Genie GTH-4013 SX Operator's Manual

First Edition - Second Printing

ORDINARY MAINTENANCE

A wrong or neglected maintenance can result in
possible risks for both operator and bystanders.
Make sure maintenance and lubrication are carried
out according to the manufacturer's instructions to
keep the machine safe and efficient.
The maintenance interventions are based on the
machine working hours. Regularly check the hour-
meter and keep it in good conditions to define the
maintenance intervals correctly. Make sure any
defect detected during the maintenance is promptly
rectified before using the machine.
CAU T I ON
All "" marked operations must be carried out
by a skilled technician.
During the first 10 working hours
1. Check the oil level within reduction gears, power
divider and differential gears
2. Regularly check the tightening of the wheel bolts
3. Check the tightening of all bolts and nuts
4. Check the couplings for oil leaks
Within the first 100 working hours
1. Change the oil of the differential casing, the
wheel reducer and the power divider gearbox.
Part No. 57.0009.0540 GTH-4013 SX - GTH-4017 SX - GTH-4013 EX - GTH-4017 EX
Every 10 working hours or daily
1. Check the engine oil level.
2. Clean the air suction filter.
3. Check the engine coolant level.
4. Clean the radiator, if necessary.
5. Check the hydraulic oil level in the tank.
6. Check the greasing of the boom section pads.
7. Grease the attachment holding frame.
8. Grease all joints of the boom, the rear axle shaft
joint, the transmission shafts, the front and rear
axles and any equipment of the machine.
9. Check the efficiency of the overload warning
system.
10. Check the efficiency of the lighting electric
system.
11. Check the efficiency of braking system and
parking brake.
12. Check the efficiency of the steering selection
system.
13. Check the efficiency of the fork balancing
system.
14. Make sure the safety devices installed are in
efficient working order.
15. Check or re-sequence the boom telescopes.
Every 50 working hours or weekly
Jobs to be done in addition to those above
1. Check the tension of the alternator belt.
2. Check the tyre inflation.
3. Check the tightening of the wheel nuts.
4. Check the tightening of the Cardan shaft screws.
5. Clean the radiator fins.
Every 250 working hours or monthly
Jobs to be done in addition to those above
1. Check the oil level in the front and rear
differential gears.
2. Check the oil level in the four wheel reduction
gears.
3. Check the main filtering element of the engine
air filter. Replace, if necessary.
4. Check the clamping of the cableheads to the
battery terminals.
Operator's Manual
Maintenance
99
Courtesy of Crane.Market