Table of Contents
Advertisement
First Edition - Second Printing
Descriptions
34_Warning light - glow plugs preheating
This light comes on during the pre-heating of the
engine glow plugs.
35_Warning light - low battery charge
Signals a low charge by the alternator.
36_Warning light - low engine oil pressure
It lights when the engine oil pressure is too low.
37_Warning light - air fi lter restricted
When this lamp comes on, proceed with cleaning or
changing the air filter cartridge.
38_Not Active
39_Warning light - parking brake engaged
When ON, this light indicates that the parking brake
is engaged.
40_Warning light - low brake pressure
It lights when the pressure of the braking circuit is
too low for a correct functioning.
41_Warning light - high beam
Warning light that signals when high beam is ON.
42_Warning light - turn signals
Indicator light that signals when turn signals are ON.
43_Warning light - position lights
Warning light that signals when position lights are ON.
44_General alarm warning light
This red light comes on to warn of a problem of the
machine. Contact the TEREXLIFT Service Centre.
45_Warning light - low hydraulic oil level
This light comes on to alert to a low level of the
hydraulic oil for a correct functioning. Replenish and
eliminate the oil leak
Part No. 57.0009.0540
GTH-4013 SX - GTH-4017 SX - GTH-4013 EX - GTH-4017 EX
Controls And Instruments
46_Warning light - hydraulic oil fi lter clogged
When this lamp sets to on, immediately change the
oil filter on the return line to the tank.
47_Warning light - machine levelling (ONLY
WITH MAN-PLATFORM)
Indicator light that signals when the machine on
outriggersis levelled within a range of -/+ 2°.
48_Engine coolant temperature indicator
This indicates the engine coolant temperature. If the
finger is in the red zone and the warning light 48.1
comes on, you must stop the machine and find and
rectify the problem.
49_Hour-meter
Signals the total operating hours of the machine. Use
the hour-meter to gauge the routine maintenance jobs.
50_Hydraulic oil temperature indicator
This indicates the temperature of the hydraulic
oil in the tank. If the temperature rises above the
permissible value or the warning light 50.1 comes
on, you must stop the machine and find and rectify
the problem.
51_Fuel gauge
This indicates the fuel level in the tank. If the fuel
level is low (reserve), the relevant warning light 51.1
comes on.
52_Warning light - control box error
This red light comes on to warn of a problem of
the machine MC2M control box. When a failure
is signalled, warning light 52 starts flashing
representing an alarm code. The meaning of these
alarm codes is shown in section "Faults and
Troubleshooting".Contact the TEREXLIFT Service
Centre.
Operator's Manual
53
Courtesy of Crane.Market
Advertisement
Table of Contents
