Operator's Manual
Maintenance
CHECKING THE OIL LEVEL IN THE TANK
CAUTION
Fine jets of hydraulic oil under pressure can
penetrate the skin. Do not use your fi ngers, but
a piece of cardboard to detect oil leaks.
Visually check the hydraulic oil level through level A
located on the reservoir and visible through the slot
on the right side of the chassis.
When necessary, add new oil through filler B.
SERVICE INTERVAL
Running-in _________ Within the first
Ordinary __________________ Every
PROT ECT T H E
EN V I RON M EN T
The handling and disposing of used oils can be
ruled by local or national regulations. Address
to authorised centres.
106
GTH-4013 SX - GTH-4017 SX - GTH-4013 EX - GTH-4017 EX
CHANGING THE HYDRAULIC OIL
To change the hydraulic oil, proceed as follows:
1 Stop the machine on a level ground and make
sure the parking brake is engaged.
2 Release the pressure from the hydraulic circuit.
3 Place a container of suitable size under the drain
plug, placed in the lower part of the reservoir, and
collect any oil leaks.
4 Remove the drain plug C and allow oil to flow out
into the container.
5 Remove the inspection cover of tank D.
6 Carefully wash the tank with Diesel oil and blow
a jet of compressed air.
7 Refit the drain plug and the inspection cover.
8 Add new oil by making sure that it matches the
recommended type until it is level with A.
10
hours
50
hours
Running-in __________________________ None
Ordinary ________________Every
First Edition - Second Printing
SERVICE INTERVAL
1000
Part No. 57.0009.0540
Courtesy of Crane.Market
hours