Table of Contents
Advertisement
Operator's Manual
Optional Attachments
900 KG EXTENSION JIB
(code 59.0802.3009 _ Hydraulic Version)
TECHNICAL DATA
Width
Height in resting position 2
Length
Height in working position 1
Weight
Payload
CoG
DANGER
•
Do not allow suspended loads to oscillate.
Do not drag loads when they are hooked up.
•
A suspended load has a dynamic, and
therefore an unpredictable effect on machine
stability, operate with caution.
Make sure this attachment can be used in the
destination country of the machine.
Application must be submitted directly by the
user.
For the use of this attachment, read the specifi c
manual.
146
GTH-4013 SX - GTH-4017 SX - GTH-4013 EX - GTH-4017 EX
Application
Quick-coupling fitted attachment for maintenance
interventions at high working heights.
Safety
Strictly obey the general safety precautions given
in section "Safety".
Never lift wrongly slung loads.
Avoid abrupt acceleration or deceleration.
Avoid load oscillations, and especially do not move
the load from the vertical pull line.
Do not pull crosswise and do not tow.
Operation
•
Couple the jib and hold it in position by means
of the attachment locking system (mechanical
or hydraulic).
1190 mm
•
Set the attachment supports in working position
1220 mm
1, using the dedicated pins A.
4485 mm
•
Lift the attachment support 3 locking it in working
position by means of the dedicated pin B.
1610 mm
•
All loads must be bridled with special textile
320 kg
slings or chains in compliance with all pertinent
900 kg
regulations.
1400 mm
•
To handle the load, raise and rotate the
telescopic boom of the handler.
•
To remove the attachment, set the supports in
resting position 2, lower the attachment support
3 locking it in resting position by means of the
dedicated pin B, carefully tilt the attachment
forward, lower the boom resting the attachment
on the ground, then retract the boom.
Once the attachment quick connectors have been
disconnected from the boom connectors, take care
to reconnect them to the proper rest connectors that
are present on the jib, in order to prevent impurities
from entering the circuit. Carefully protect the rest
connectors with the proper plugs when they are not
used.
Maintenance
Visually check the jib for damage before using it.
Check the safety catch is in good working order.
Daily grease the joints using the greasing gun.
First Edition - Second Printing
Part No. 57.0009.0540
Courtesy of Crane.Market
Advertisement
Table of Contents
