Table of Contents
Advertisement
First Edition - Second Printing
MICRO-SWITCHES on the OUTRIGGERS
When the outriggers are lowered to the ground:
-
the overload warning system changes the
meter scale
-
the transmission is deactivated
Checking the micro-switches of the outriggers
(at every use)
To check the micro-switches of the outriggers:
•
Lower the outriggers to the ground and attempt
to engage a gear.
If the gear can be engaged, contact the
TEREXLIFT Technical Assistance Service.
Proceed on one outrigger at a time.
•
With the outriggers up, light 4 on the load limiter
panel must be off; with the outriggers down to the
ground, the same light must be on. Should it not
be the case, contact the TEREXLIFT Technical
Service.
WARNING
If a micro-switch is faulty or a lever is deformed,
immediately replace the part.
Part No. 57.0009.0540
A
A
A
GTH-4013 SX - GTH-4017 SX - GTH-4013 EX - GTH-4017 EX
Emergency stop pushbutton
On the dashboard, to the right of the steering wheel.
Pressing down this button stops the engine of
the machine.
Before starting work again, find and rectify the
relevant causes, then reset the button to neutral
position turning it clockwise.
Checking the emergency stop pushbutton (at
every use)
To check the efficiency of this pushbutton, simply
press it down during a movement. The pressure of
the pushbutton shall cause the movement to stop
and the engine to shut down.
Operator's Manual
Maintenance
117
Courtesy of Crane.Market
Advertisement
Table of Contents
