Specifications - Genie S-105 Service Manual

June 2011
1 2 3 4 5 6 7 8 9 0 1 2 3 4
1 2 3 4 5 6 7 8 9 0 1 2 3 4
1 2 3 4 5 6 7 8 9 0 1 2 3 4
REV B REV C REV B
1 2 3 4 5 6 7 8 9 0 1 2 3 4
1 2 3 4 5 6 7 8 9 0 1 2 3 4
1 2 3 4 5 6 7 8 9 0 1 2 3 4
1 2 3 4 5 6 7 8 9 0 1 2 3 4
1 2 3 4 5 6 7 8 9 0 1 2 3 4
1 2 3 4 5 6 7 8 9 0 1 2 3 4
2 Press and hold the enter button
ground control panel while turning the key
switch to ground controls. Hold the enter
button for approximately 5 seconds.
3 Press the plus button
minus button twice.
4 Press the scroll button
be adjusted is displayed.
5 Press the plus button
or press the minus button
speed.
6 Press the enter button
memory.
7 Push one of the LCD
screen buttons shown
until is displayed.
EXIT
8 Press the plus button to select
press the enter button
9 Continue to perform this procedure until the
machine function speed meets specification.
Refer to Section 2, Specifications for function
speeds.
How to Adjust the Function
Ramp Rate Setting
The ramp rate setting of a joystick controls the time
at which it takes for the joystick to reach maximum
output, when moved out of the neutral position. The
ramp rate settings of a joystick can be changed to
compensate for hydraulic pump wear to maintain
peak performance from the machine.
Note: Perform this procedure with the boom in the
stowed position.
1 Pull out the red Emergency Stop button to the
on position at both the ground and platform
controls.
Part No. 102916
on the
twice, then press the
until the function to
to increase the speed
to decrease the
to save the setting in
and then
YES
.
S-100 • S-105 • S-120 • S-125
Section 4 • Repair Procedures
2 Press and hold the enter button
ground control panel while turning the key
switch to ground controls. Hold the enter
button for approximately 5 seconds.
3 Press the plus button
scroll button twice.
4 Press the scroll button
be adjusted is displayed.
5 Press the plus button
rate or press the minus button
the ramp rate.
6 Press the enter button
memory.
7 Push one of the LCD
screen buttons shown
until is displayed.
EXIT
8 Press the plus button to select
press the enter button

Specifications

Ramp rate (factory settings)
Turntable rotate
accelerate
decelerate
Primary boom up/down
accelerate
decelerate
Primary boom extend/retract
accelerate
decelerate
Jib boom up/down
accelerate
decelerate
Drive
accelerate
PLATFORM CONTROLS
on the
twice, then press the
until the function to
to increase the ramp
to decrease
to save the setting in
and then
YES
.
2 seconds
0.25 second
3 seconds
0..25 second
2 seconds
0.25 second
2 seconds
0.25 second
2 seconds
4 - 15