Perform Engine Maintenance - Deutz Models; Replace The Boom Extend/Retract Cables - Genie S-105 Service Manual

June 2011
REV C REV B
E-12
Perform Engine Maintenance -
Deutz Models
Engine specifications require that this procedure be
performed every 12000 hours.
Proper engine maintenance, following the engine
manufacturer's maintenance schedule, is essential
to good engine performance and service life. Failure
to perform the maintenance procedures can lead to
poor engine performance and component damage.
Required maintenance procedures and additional
engine information are available in the
Deutz F4L913 Operation Manual
(Deutz part number 0297 7341) OR the
Deutz BF4L2011 Operation Manual
(Deutz part number 0297 9929).
Deutz F4L913 Operation Manual
Genie part number
Deutz BF4L2011 Operation Manual
Genie part number
To access the engine:
1 Remove the engine tray retaining fastener
located under the engine tray. Swing the engine
tray out and away from the machine.
2 Install the fastener that was just removed
through the engine tray and into the engine tray
anchor hole in the turntable.
Crushing hazard. Failure to install
the fastener into the engine tray
anchor hole to secure the engine
tray from moving could result in
death or serious injury.
Part No. 102916
Section 3 • Scheduled Maintenance Procedures
E-13
Replace the Boom Extend/
Retract Cables
Genie specifications require that this procedure be
performed every 10 years.
The boom extend/retract cables are responsible for
the extension and retraction of the number 3 boom
tube on the S-100 and S-105, and the numbers 2
and 3 boom tubes on the S-120 and S-125.
Replacement of the boom extend/retract cables is
essential to good machine performance and safe
machine operation. The boom extend/retract
functions should operate smoothly and be free of
hesitation, jerking and unusual noise.
1 Replace the boom extend cables. Refer to
Repair Procedure 4-5, How to Replace the
Boom Extend/Retract Cables.
62446
84794
S-100 • S-105 • S-120 • S-125
CHECKLIST E PROCEDURES
3 - 69