Jib Boom Components, S-105 And S-125 Models - Genie S-105 Service Manual

Section 4 • Repair Procedures

JIB BOOM COMPONENTS, S-105 AND S-125 MODELS

12 Remove the pin retaining fasteners from the jib
boom lift cylinder rod-end pivot pin. Do not
remove the pin.
13 Slide both of the jib boom leveling arms off of
the jib boom pivot pin and lay them off to the
side.
14 Attach a lifting strap from an overhead crane to
the lug on the rod end of the jib boom lift
cylinder.
15 Use a soft metal drift to remove the jib boom lift
cylinder rod-end pivot pin. Remove the jib boom
lift cylinder from the jib boom bellcrank.
Crushing hazard. The jib boom lift
cylinder may become unbalanced
and fall when it is removed from
the machine if it is not properly
supported.
16 Attach a lifting strap from an overhead crane to
the jib boom bellcrank.
17 Support the rod end of the platform leveling
cylinder with a suitable lifting device. Protect the
cylinder rod from damage.
4 - 26
18 Remove the pin retaining fastener from the
platform leveling cylinder rod-end pivot pin.
19 Use a soft metal drift to remove the platform
leveling cylinder rod-end pivot pin.
20 Remove the pin retaining fastener from the jib
boom bellcrank pivot pin.
21 Use a soft metal drift to remove the jib boom
bellcrank pivot pin. Remove the jib boom
bellcrank from the machine.
S-100 • S-105 • S-120 • S-125
Crushing hazard. The platform
leveling cylinder may fall if it is not
properly supported when the rod-
end pivot pin is removed.
Crushing hazard. The jib boom
bellcrank may fall if it is not
properly supported when the
platform leveling cylinder rod-end
pivot pin is removed.
Crushing hazard. The jib boom
bellcrank may become
unbalanced and fall if it is not
properly supported when it is
removed from the machine.
Part No. 102916
June 2011
REV A