Oil Pressure And Coolant Temperature Sending Units, Cummins And Perkins Models; Oil Pressure And Temperature Sending Units, Deutz Models - Genie S-105 Service Manual

June 2011
REV B
6-3
Oil Pressure and Coolant
Temperature Sending Units -
Cummins and Perkins Models
The coolant temperature sending unit is an
electrical device. If the coolant temperature
reaches 210° F / 99° C, the ECM will shut the
engine off to prevent damage and will not start until
the coolant temperature drops below
210° F / 99° C. The engine temperature will be
shown on the display screen at the ground controls
when the key is and the Emergency Stop Button
ON
is pulled out to the position. Use the scroll
ON
buttons and scroll to the E
Component damage hazard.
Do not crank the engine with
a water temperature fault shown
on the display at the ground
controls.
The oil pressure sending unit is an electrical
device. If the oil pressure drops below
12 psi / 0.8 bar, the ECM will shut the engine off to
prevent damage. The engine oil pressure will be
indicated on the display screen at the ground
controls while the engine is running. Use the scroll
buttons and scroll to the E
screen.
Component damage hazard.
Do not crank the engine with a low
oil pressure fault shown on the
display at the ground controls.
Part No. 102916
T screen.
NGINE EMPERATURE
O P
NGINE IL RESSURE
S-100 • S-105 • S-120 • S-125
Section 4 • Repair Procedures
6-4
Oil Pressure and Temperature
Sending Units - Deutz Models
The engine oil temperature sending unit is an
electrical device. If the engine oil temperature
reaches 275° F / 135° C, the ECM will shut the
engine off to prevent damage and will not start until
the engine oil temperature drops below
275° F / 135° C. The engine temperature will be
shown on the display screen at the ground controls
when the key is and the Emergency Stop Button
ON
is pulled out to the position. Use the scroll
ON
buttons and scroll to the Engine Temperature
screen.
Component damage hazard.
Do not crank the engine with
a oil temperature fault shown on
the display at the ground controls.
The oil pressure sending unit is an electrical
device. If the oil pressure drops below
12 psi / 0.8 bar, the ECM will shut the engine off to
prevent damage. The engine oil pressure will be
indicated on the display screen at the ground
controls while the engine is running. Use the scroll
buttons and scroll to the Engine Oil Pressure
screen.
Component damage hazard.
Do not crank the engine with a low
oil pressure fault shown on the
display at the ground controls.
ENGINES
4 - 57