Perform Engine Maintenance - Perkins Models - Genie S-105 Service Manual

June 2011
REV C REV B
E-8
Perform Engine Maintenance -
Perkins Models
Engine specifications require that this procedure be
performed every 4000 hours.
Proper engine maintenance, following the engine
manufacturer's maintenance schedule, is essential
to good engine performance and service life. Failure
to perform the maintenance procedures can lead to
poor engine performance and component damage.
Required maintenance procedures and additional
engine information are available in the
Perkins 1004 User's Handbook
(Perkins part number TPD 1349E) OR the
Perkins 1100 Series User's Handbook
(Perkins part number TPD 1477).
Perkins 1004 User's Handbook
Genie part number
Perkins 1100 Series User's Handbook
Genie part number
To access the engine:
1 Remove the engine tray retaining fastener
located under the engine tray. Swing the engine
tray out and away from the machine.
2 Install the fastener that was just removed
through the engine tray and into the engine tray
anchor hole in the turntable.
Crushing hazard. Failure to install
the fastener into the engine tray
anchor hole to secure the engine
tray from moving could result in
death or serious injury.
Part No. 102916
Section 3 • Scheduled Maintenance Procedures
E-9
Perform Engine Maintenance -
Perkins Models
Engine specifications require that this procedure be
performed every 6000 hours or 3 years, whichever
come first.
Proper engine maintenance, following the engine
manufacturer's maintenance schedule, is essential
to good engine performance and service life. Failure
to perform the maintenance procedures can lead to
poor engine performance and component damage.
Required maintenance procedures and additional
engine information are available in the
Perkins 1004 User's Handbook
(Perkins part number TPD 1349E) OR the
Perkins 1100 Series User's Handbook
(Perkins part number TPD 1477).
61376
Perkins 1004 User's Handbook
Genie part number
107526
Perkins 1100 Series User's Handbook
Genie part number
To access the engine:
1 Remove the engine tray retaining fastener
located under the engine tray. Swing the engine
tray out and away from the machine.
2 Install the fastener that was just removed
through the engine tray and into the engine tray
anchor hole in the turntable.
S-100 • S-105 • S-120 • S-125
CHECKLIST E PROCEDURES
Crushing hazard. Failure to install
the fastener into the engine tray
anchor hole to secure the engine
tray from moving could result in
death or serious injury.
61376
107526
3 - 67