Check The Dirve Hub Oil Level And Fastener Torque - Genie S-105 Service Manual

Section 3 • Scheduled Maintenance Procedures
CHECKLIST B PROCEDURES
B-10
Check the Drive Hub Oil Level
and Fastener Torque
Genie requires that this procedure be performed
every 250 hours or quarterly, whichever comes
first.
Failure to maintain proper drive hub oil levels may
cause the machine to perform poorly and continued
use may cause component damage.
Drive hubs:
1 Drive the machine to rotate the hub until the
plugs are located one at the side and the other
at the other side.
a drive hub plugs
2 Remove both plugs and check the oil level.
Result: The oil level should be even with the
bottom of the plug holes.
3 If necessary, add oil until the oil level is even
with the bottom of the plug holes.
4 Install the plugs in the drive hub.
5 Check the torque of the drive hub mounting
fasteners. Refer to Section 2, Specifications.
6 Repeat this procedure for each drive hub.
3 - 24
Turntable Rotate Drive Hub:
1 Remove the fixed turntable cover at the ground
controls side of the machine.
2 Remove the power to platform plug panel upper
retaining fasteners and loosen the lower
retaining fasteners. Do not disconnect the
wiring.
3 Support the cover with a suitable lifting device.
Protect the cover from damage.
4 Remove the cover retaining fasteners. Remove
the cover from the machine.
5 Remove the plug located on the top of the drive
a brake and check the oil level.
Result: The oil level should be even with the
bottom of the plug hole.
S-100 • S-105 • S-120 • S-125
Crushing hazard. The turntable
cover may become unbalanced
and fall when it is removed from
the machine if it is not properly
supporte
Part No. 102916
June 2011
REV E