Hydraulic Oil Specifications - Genie S-105 Service Manual

Section 2 • Specifications
SPECIFICATIONS

Hydraulic Oil Specifications

Hydraulic Oil Specifications
Hydraulic oil type
Viscosity grade
Viscosity index
Cleanliness level, minimum
Water content, maximum
Chevron Rando HD oil is fully compatible and
mixable with Shell Donax TG (Dexron III) oils.
Genie specifications require hydraulic oils which are
designed to give maximum protection to hydraulic
systems, have the ability to perform over a wide
temperature range, and the viscosity index should
exceed 140. They should provide excellent antiwear,
oxidation, corrosion inhibition, seal conditioning, and
foam and aeration suppression properties.
Optional fluids
Biodegradable
Fire resistant
Mineral based
Continuous improvement of our products is a
Genie policy. Product specifications are subject
to change without notice.
2 - 6
Chevron Rando HD Premium
MV Equivalent
Multi-viscosity
15/13
200 ppm
Petro Canada Environ MV46
Statoil Hydra Way Bio Pa 32
BP Biohyd SE-S
UCON Hydrolube HP-5046
Quintolubric 822
Shell Tellus T32
Shell Tellus T46
Chevron Aviation A
S-100 • S-105 • S-120 • S-125
Note: Use Chevron Aviation A hydraulic oil when
ambient temperatures are consistently
200
below 0°F / -18°C.
Note: Use Shell Tellus T46 hydraulic oil when oil
temperatures consistently exceed 205°F / 96°C.
Note: Genie specifications require additional
equipment and special installation instructions for
the approved optional fluids. Consult the Genie
Industries Service Department before use.
Continued use of Chevron Aviation
A hydraulic oil when ambient
temperatures are consistently
above 32°F / 0°C may result in
component damage.
Part No. 102916
June2011
REV E