Comtech EF Data CDM-625 Installation And Operation Manual page 314

CDM-625 Advanced Satellite Modem
Remote Control
D.7.7 BUC Commands (L-Band Device)
Command
Parameter
(Instruction
Type
& Qualifier)
BUC BPS= 1 byte, value
Power Supply of 0 or 1
enable
Exception
600L emulation:
ODP=
BUC BFR= 1 byte
10 MHz
Reference
Exception
600L emulation:
ODR=
BUC BCL= 4 bytes
Current
Low Limit
Exception
600L emulation:
ODL=
BUC BCH= 4 bytes
Current
High Limit
Exception
600L emulation:
ODH=
BUC BAD= 1 byte, value
Address of 1 to 15
Exception
600L emulation:
OAD=
BUC BOE= 1 byte, value
Output Power of 0 or 1
Enable
Exception
600L emulation:
OOP=
Number of
Description of Arguments
Arguments
Command or Query.
Power Supply control:
0=Disable the BUC DC Power Supply
1=Enable the BUC DC Power Supply
Command or Query.
Where x is either 0(OFF) or 1(ON).
Command or Query.
BUC Current Low Limit, a value between 0 and 4000mA, in
100mA increments.
Command or Query.
BUC Current High Limit, a value between 0 and 4000mA, in
100mA increments.
Command or Query.
BUC Address, in the form: xx, where xx is between 1 and 15.
Note: This command is only valid when the FSK and BUC power
are enabled.
Command or Query.
BUC Tx Carrier Output Power Enable, either 0(OFF) or 1(ON).
Note: This command is only valid when the FSK and BUC power
are enabled.
D–54
Revision 1
MN-0000036 (Ref MN/CDM625.IOM)
Response Query
to (Instruction & Response to Query
Command Qualifier)
BPS= BPS? BPS=x
BPS? (see description of
BPS* arguments)
BPS#
Exception
600L emulation:
ODP?
BFR= BFR? BFR=x
BFR? (see description of
BFR* arguments)
Exception
BFR#
600L emulation:
ODR?
BCL= BCL? BCL=xxxx
BCL? (see description of
BCL* arguments)
Exception
BCL#
600L emulation:
ODL?
BCH= BCH? BCH=xxxx
BCH? (see description of
BCH* arguments)
Exception
BCH#
600L emulation:
ODH?
BAD= BAD? BAD=xx
BAD? (see description of
BAD* arguments)
BAD#
Exception
600L emulation:
OAD?
BOE= BOE? BOE=x
BOE? (see description of
BOE* arguments)
BOE#
Exception
600L emulation:
OOP?