CDM-625 Advanced Satellite Modem
Front Panel Operation
5.4.9
CONFIG: EDMAC
EDMAC Mode= Idle
EDMAC is a Comtech-proprietary framing which permits communication access to the distant-
end modem. For further information, refer to Chapter 11. EDMAC CHANNEL. In order to edit
the EDMAC mode, the framing must be set for EDMAC, EDMAC-2 or D&I++.
EDMAC Mode= Master (Idle,Master,Slave)
EDMAC Address= 0020
Select the mode using the
show an address. Use the
keys to edit the value. Press ENTER when done.
•
An EDMAC Master is a modem which is local to the M&C computer, and which passes
messages, via the overhead, to a distant-end modem. The Master address will always end in
0.
•
An EDMAC Slave is a modem that is not local to the M&C computer. It is at the 'distant-
end' of a satellite link. The Slave EDMAC address will always end in 1. When configured
as a Slave, re-configuration is expected to be via the EDMAC link, and hence is not
permitted via the front panel or via serial remote control.
(Idle,Master,Slave)
arrow keys. If the mode is Master or Slave, the lower line will
▲ ▼
◄ ►
arrow keys to select the character to edit, then the
5–32
MN-0000036 (Ref MN/CDM625.IOM)
(34v)
(34v)
▲ ▼
Revision 1
arrow