Stabilization Menu - Furuno FCV-2100 Operator's Manual

4. ADVANCED SETTINGS
4.7.6

Stabilization menu

You can adjust for heave in the [Stabilization] section of the [System] menu.
Note 1: This function require connection to a SATELLITE COMPASS
inactive if data from the SATELLITE COMPASS
Note 2: This function is unavailable if [TX Triggering] is set to [On] at installation.
FCV-2100 [ver 02524476-xx.xx]
Menu item
[Stabilization]
[Stabilization Sensor]
[Delay Time]
[Stabilization Area]
[TD fore-aft]
[TD port-stbd]
[ANT TD height]
4-14
Sounder
Display
Stabilization
Measurement
Stabilization Sensor
Alarm
Delay Time
System
Stabilization Area
Range
TX/RX
TD fore-aft
Control Unit
TD port-stbd
User Interface Settings
ANT TD height
Calibration
Stabilization
Mode
Tests
Service
Turn heaving compensation on or off. Turn it on when seas are rough, to
get stable echoes, regardless of sea conditions. When turned on, the sta-
bilization icon (
header.
Note: Where data from the SATELLITE COMPASS
the stabilization icon is overlaid with a cross to indicate that it is not in use.
When data from the SATELLITE COMPASS
is removed.
Set at installation. Indicates the SATELLITE COMPASS
the FCV-2100.
Do not change this setting.
Set at installation. Available only when [Stabilization Sensor] is set to
[Manual]. Do not change this setting.
When heaving exceeds the value set here, stabilization is stopped and the
stabilization icon at the top of the screen is displayed with an "X", indicating
it has stopped. However, the setting for [Stabilization] is kept [On]. When
heaving is once again less than the value set here, stabilization is restart-
ed and the "X" disappears.
Set at installation.Indicates the location and height of the SATELLITE
™
COMPASS antenna.
Do not change these settings.
™
is interrupted or lost.
Stabilization
Off
SC-50
250
20
0.0
0.0
0.0
OK Apply
Description
) appears in the [Picture Advance] section of the
™
™
and becomes
Cancel
™
is interrupted or lost,
is received again, the cross
™
connected to