Mode Menu - Furuno FCV-2100 Operator's Manual

4.7.7

Mode menu

You can "split" the display screen from the [Mode] section of the [System] menu. This
allows you to display different information across two or more sections of the display.
FCV-2100 [ver 02524476-xx.xx]
Sounder
Display
Measurement
Alarm
External Echo Sounder
Sounder
HF
LF
Calibration
TX/RX
System
Range
TX/RX
Control Unit
User Interface Settings
Calibration
Stabilization
Mode
Tests
Service
For details on split screen modes, see "SCREEN LAYOUTS" on page AP-5.
How to add a mode
You can add up to 8 modes. To add a mode, do the following:
1. Select the appropriate contents drop-down from the right-side of the menu. The
contents are listed in line with their respective modes, as indicated in the figure
above.
FCV-2100 [ver 02524476-xx.xx]
Sounder
Display
Measurement
Alarm
External Echo Sounder
Sounder
HF
LF
Calibration
TX/RX
System
Range
TX/RX
Control Unit
User Interface Settings
Calibration
Stabilization
Mode
Tests
Service
You can select up to four items to be displayed for each mode.
Mode
No Mode
1 NF Normal
2 ZM-NF
Not selected
Not selected
Not selected
OK
Mode
No Mode
1 NF Normal
2 ZM-NF
Not selected
Not selected
Not selected
OK
Contents of screen1
(Fixed at [Normal]).
NF
Contents of screen2
Contents of screen3
Contents of screen4
Mode list. The currently selected
mode is highlighted in blue.
Select to add a new mode.
Add
Select to refresh the mode list.
Refresh
Delete Select to delete the current mode.
Apply
Cancel
NF
Items selected for the current
display mode are abbreviated
and shown in these two locations.
Add
Refresh
Delete
Apply Cancel
4. ADVANCED SETTINGS
4-15