Stabilization] Menu - Furuno FSS-3BB Installation Manual

Menu item
[Gain ADJ]
6. Select [LF] from the menu on the left-hand side of the window, then set up the LF
(low frequency) transducer in a similar manner.
7. Click the [OK] button to apply the settings and close the menu.
3.5

[Stabilization] Menu

The [Stabilization] menu compensates for the effects of heaving, and requires a SAT-
ELLITE COMPASS
Note 1: The heaving feature requires the connection with a SATELLITE COMPASS
The heaving feature is not available when there is no data from a SATELLITE COM-
™
PASS .
Note 2: Set the SATELLITE COMPASS
ator's manual for setting details.
• Output sentence: ATT (GPatt), HVE (GPhve)
• Baud rate: 38,400 bps
• Transmission rate: 25 ms or less
• IEC edition version setting (SC-50/SC-110 only): IEC ED1
Note 3: The heaving feature is not available when the [In Trigger] on the [Shared Set-
tings] menu (see section 3.2.2) is set to [On].
1. Click the [Settings] icon (
vanced Settings] icon (
2. Select [Stabilization] from the menu on the left-hand side of the window.
The [Stabilization] menu appears on the right-hand side of the window.
3. Set the menu items, referring to the following table.
Menu item
[Stabilization]
If the gain is too high or too low, or the gain for the low and high
frequencies appears unbalanced, you can compensate it here
(setting range: -50 to +50).
™
.
).
××.××
Advanced Settings
IDENTI-FISH
ID1
Stabilization
ID2
Stabilization Sensor
A A larm
System Syst em
Dela Delay Ti y Time [ me [msec msec]
Range
Stabilization Area
TX/RX
HF
LF
Control Unit
User User Int Interfa erface S ce Setti ettings ngs
Calibration
HF HF
LF
Stab Stabiliz ilizatio ation n
HF HF
LF
Mode Mode
Test Tests s
Service Serv ice
Turn heaving compensation on or off. Turn it on when seas are
rough, to get stable echoes. When turned on, the stabilization
icon (
header.
Description
™
output as follows. Refer to respective oper-
) from the InstantAccess bar
System : Stabilization y
Off
SC-50
] 0
20
Description
) appears in the [Picture Advance] section of the
3. INITIAL SETTINGS
™
™
, then click the [Ad-
3-15
.