Stabilization Setting - Furuno FCV-1900/B/G Installation Manual

the calibration ratio by comparison with the fish size shown on the display and the ac-
tual fish size.
Fish size
Calibration =
value (%)
3.7

Stabilization Setting

The [Stabilization] menu compensates for the effects of heaving, and requires a Sat-
ellite Compass
Stabilization
Stabilization Sensor
Stabilization Area
[HF]
TD fore-aft
TD port-stbd
ANT TD height
[LF]
TD fore-aft
TD port-stbd
ANT TD height
[Stabilization]: Turn heaving compensation on or off. Turn it on when seas are rough,
to get stable pictures regardless of sea conditions. When heaving stabilization is
turned on, the symbol (
antenna position of the Satellite Compass
low appears. Push the knob to erase the message and set the antenna position of the
Satellite Compass
[Stabilization Area]: When heaving exceeds the value set here, stabilization is
stopped and the stabilization icon at the top of the screen disappears. However, [Sta-
bilization] is kept [On]. When heaving is once again less than the value set here, sta-
bilization is restarted and the stabilization icon reappears.
Note: For the heaving feature, set the SC-30/50/110 Satellite Compass
follows.
Feature
Sentence
Baud rate
0.197
TVR + RVR
10
™
. It is inoperative when there is no data from the Satellite Compass
On
SC-50
15m
0.0m
0.0m
0.0m
0.0m
0.0m
0.0m
) appears at the upper left corner on the screen. If the
™
.
Antenna to Transducer
distances (bow-stern,
port-starboard, height)
are not set, Have a
FURUNO technician
adjust your settings.
Yes
SC-50/110 (Data out setting)
ATT, HVE
38400 bps
26
- 1 ×100
20
Stabilization Sensor SC-30
Stabilization Area 15m
[HF]
0.0m
TD fore-aft
TD port-stbd 0.0m
ANT TD height 0.0m
[LF]
TD fore-aft 0.0m
0.0m
TD port-stbd
0.0m
ANT TD height
™
has not been set, the message shown be-
SC-30 (IF-NMEASC setting)
ATT, HVE
38400 bps
3. INITIAL SETTINGS
™
.
™
output as