Home Screen ������������������������������������������������������������������������� 38 Telemetry:temperature - FUTABA R7108SB Full Manual

Home Screen
This is the Home screen and descriptions of its menus. Use your finger to operate the touch screen.
Battery voltage for receivers
• In FASSTest/T-FHSS mode, this
data displayed. RX voltage
and Ext voltage display
The reception of the signal from the
receiver to the transmitter is shown.
• This does not affect flight.
Timer1, Timer2
• Timer is displayed here.
Tap the time button to start/stop the
timer. (When the screen is tapped for
1 second, timer is reset to the initial
value.)
→ (Menu)
• System
• Linkage
• Model select
Tap the button to call each Menu
screen.
System timer
• This shows the accumulated time
since the latest reset. (Each model /
Total)
(Hour):(Minute):(Second)
WARNING
Be sure to confirm the model name before flying your aircraft.
Check the battery voltage as often as possible and try to charge the battery earlier.
If the battery alarm makes a sound, land your aircraft immediately.
*You can adjust the LCD contrast by the display setting in the system menu.
Condition name
• The condition name
that is currently used
is displayed here.
User's name
38
Battery Indicator
• When battery is low, the alarm
will beep. Land your aircraft
immediately.
→ (Menu)
• Model menu
Tap the Icon to call Model
Menu screen.
System mode
• System(FASSTest18CH etc.)
Type is displayed here.
RF Indicator
Model Name
• The model name that
is currently used is
displayed here.
Digital trim (T1 to T4)
• Trim position is displayed
here.