Program Mixing (1, 2, 3, 4, 5 ) - FUTABA 7XC Instruction Manual

These functions allow you to apply mixing between the steering, throttle and auxiliary
channel.
Additional Functions
-When the steering or throttle channel is the master channel (channel that applies mix-
ing), trim data can be added. (Trim mode)
- The mixing mode selection. (Master mixing mode)
- The master channel mixing center point (point at which the direction changes) can be
offset. (Offset function)
Movement of the slave channel side
The movement of the master channel side will include movement of the slave channel
side.
When Throttle mode (Trigger) ratio was set to 100:0
When " Throttle mode (Trigger) Ratio " (page 60) is set to 100:0, brake operation stops.
When the master channel is set to throttle, mixing operates only at the " Rate A (forward) "
side. It does not operate at the " Rate B (brake) " side.
Home screen
When the number of channels is insuf-
昀椀cient, cancel the other mixing.
120

Program Mixing (1, 2, 3, 4, 5 )

Menu screen
Menu-1
Program Mixing (1, 2, 3, 4, 5)
Menu-2
On the page 1, the setting screen such as the curve, mix-
ing rate adjustment screen, page 2, mixing ON / OFF etc.
is displayed.
Program mixing