Table of Contents
Advertisement
Commands
The commands used to review and configure the Cisco discovery protocol are listed below. Refer
also to "show neighbors" on page 4‐6.
For information about...
show ciscodp
show ciscodp port info
set ciscodp status
set ciscodp timer
set ciscodp holdtime
set ciscodp port
clear ciscodp
show ciscodp
Use this command to display global Cisco discovery protocol information.
Syntax
show ciscodp
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display global Cisco DP information.
B3(su)->show ciscodp
CiscoDP :Enabled
Timer :5
Holdtime (TTl): 180
Device ID : 001188554A60
Last Change : WED NOV 08 13:19:56 2006
Table
4‐2 provides an explanation of the command output.
Table 4-2 show ciscodp Output Details
Output
CiscoDP
What It Displays...
Whether Cisco DP is globally enabled or disabled. Auto indicates that Cisco DP will
be globally enabled only if Cisco DP PDUs are received.
Default setting of auto-enabled can be reset with the set ciscodp status command.
show ciscodp
Refer to page...
4-7
4-8
4-9
4-9
4-10
4-10
4-12
SecureStack B3 Configuration Guide 4-7
Advertisement
Table of Contents
