Enterasys SecureStack B3 Configuration Manual page 539

role. When a policy role is dynamically applied to a port as the result of a successfully
authenticated session, the "authenticated VLAN" is mapped to the policy role set in the Filter‐ID
returned from the RADIUS server. The "authenticated VLAN" may either be the PVID of the port,
if the PVID Override for the policy profile is disabled, or the VLAN specified in the PVID
Override if the PVID Override is enabled.
Commands
For information about...
show multiauth
set multiauth mode
clear multiauth mode
set multiauth precedence
clear multiauth precedence
show multiauth port
set multiauth port
clear multiauth port
show multiauth station
show multiauth session
show multiauth idle-timeout
set multiauth idle-timeout
clear multiauth idle-timeout
show multiauth session-timeout
set multiauth session-timeout
clear multiauth session-timeout
show multiauth
Use this command to display multiple authentication system configuration.
Syntax
show multiauth
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Refer to page...
20-31
20-32
20-32
20-33
20-34
20-34
20-35
20-35
20-36
20-36
20-37
20-38
20-39
20-39
20-40
20-41
SecureStack B3 Configuration Guide 20-31
show multiauth