clear rmon history
Use this command to delete one or more RMON history entries or reset one or more entries to
default values. For specific values, refer to "set rmon history" on page 14‐6.
Syntax
clear rmon history {index-list | to-defaults}
Parameters
index‐list
to‐defaults
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to delete RMON history entry 1:
B3(rw)->clear rmon history 1
Alarm Group Commands
Purpose
To display, configure, and clear RMON alarm entries and properties.
Commands
For information about...
show rmon alarm
set rmon alarm properties
set rmon alarm status
clear rmon alarm
show rmon alarm
Use this command to display RMON alarm entries. The RMON alarm group periodically takes
statistical samples from RMON variables and compares them with previously configured
thresholds. If the monitored variable crosses a threshold an RMON event is generated.
Specifies one or more history entries to be deleted, causing them to
disappear from any future RMON queries.
Resets all history entries to default values. This will cause entries to
reappear in RMON queries.
clear rmon history
Refer to page...
14-7
14-9
14-10
14-10
SecureStack B3 Configuration Guide 14-7