Table of Contents
Advertisement
When activating licenses with this command, Enterasys Networks recommends that you copy and
paste the entire license character string, rather than enter the text manually. If you enter the
character string manually, ensure that you exactly match the capitalization of the character string
sent to you.
Every license is associated with a specific hardware platform, based on the serial number of the
hardware platform. If you need to move a license from one hardware platform to another, you
must contact Enterasys Customer Support to arrange for re‐hosting of the license.
Example
This example shows how to activate a permanent license key on the switch with serial number
045100039001. In this example, the switch is a stand‐alone unit so its unit number is 1.
B3(rw)->set license INCREMENT policy 2006.0728 permanent 31173CAC6495
045100039001
Validating license on unit 1
License successfully validated and set on unit 1
B3(rw)->
show license
Use this command to display license key information for switches with activated licenses.
Syntax
show license [unit number]
Parameters
unit number
Defaults
If no unit number is specified, license key information for all switches in the stack is displayed.
Mode
Switch command, read‐only.
Usage
Licenses can be displayed, applied, and cleared only with the license commands described in this
chapter. General configuration commands such as show config or clear config do not affect
licenses.
Example
This example shows how to display license key informatioin for switch unit 1 in the stack.
B3(ro)->show license unit 1
unit 1
key: INCREMENT policy 2006.0728 permanent 31173CAC6495 045100039001
status: Active
(Optional) Specifies the switch in a stack for which to display license
information.
Refer to Chapter
2, Configuring Switches in a Stack, for more
information about stack unit IDs, or numbers.
SecureStack B3 Configuration Guide 3-29
show license
Advertisement
Table of Contents
