Table of Contents
Advertisement
Using the Command Line Interface
Figure 1-1
Username:admin
Password:
Enterasys SecureStack B3
Command Line Interface
Enterasys Networks, Inc.
50 Minuteman Rd.
Andover, MA 01810-1008 U.S.A.
Phone: +1 978 684 1000
E-mail: support@enterasys.com
WWW: http://www.enterasys.com
(c) Copyright Enterasys Networks, Inc. 2006
Chassis Serial Number:
Chassis Firmware Revision:
B3(su)->
Connecting Using Telnet
Once the SecureStack B3 device has a valid IP address, you can establish a Telnet session from any
TCP/IP based node on the network. For information about setting the switch's IP address, refer to
"set ip address" on page 3‐9.
To establish a Telnet session:
1.
Telnet to the switch's IP address.
2.
Enter login (user name) and password information in one of the following ways:
–
–
The notice of authorization and the prompt displays as shown in Figure
For information about configuring Telnet settings, refer to "Starting and Configuring Telnet" on
page 3‐38.
Refer to the instructions included with the Telnet application for information about establishing a
Telnet session.
Logging In
By default, the SecureStack B3 switch is configured with three user login accounts—ro for
Read‐Only access, rw for Read‐Write access, and admin for super‐user access to all modifiable
parameters. The default password is set to a blank string. For information on changing these
default settings, refer to "Setting User Accounts and Passwords" on page 3‐1.
Using a Default User Account
If this is the first time you are logging in to the SecureStack B3 switch, or if the default user
accounts have not been administratively changed, proceed as follows:
1-6 Introduction
SecureStack B3 Startup Screen
If the switch's default login and password settings have not been changed, follow the
steps listed in "Using a Default User Account" on page 1‐6, or
Enter an administratively‐configured user name and password.
041800249041
1.1.xx
1‐1.
Advertisement
Table of Contents
