Table of Contents
Advertisement
show policy maptable response
In order to authenticate multiple RFC 3580 users, policy maptable response must be set to tunnel
as described in this section.
Commands
For information about...
show policy maptable response
set policy maptable response
set vlanauthorization
set vlanauthorization egress
clear vlanauthorization
show vlanauthorization
show policy maptable response
Displays the current policy maptable response setting. When maptable response is set to policy
(the default setting) the maximum number of multiauth users allowed per port is 2. When the
maptable response is set to tunnel the maximum number of multiauth users allowed per port is 6
3. When VLAN authorization is enabled (as described in this section) and the policy maptable
response is tunnel, you can use the "set multiauth port" on page 20‐35 command to set the
number of RFC 3580 users (numusers) allowed per Gigabit port. Up to three users can be
configured per Gigabit port. .
Syntax
show policy maptable response
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display the current policy maptable response setting:
B3(rw)->show policy maptable response
policy
set policy maptable response
Sets the maptable response from the default of policy to tunnel to allow up to 3 VLAN authorized
users to be configured per Gigabit port.
20-42 Security Configuration
Refer to page...
20-42
20-42
20-43
20-44
20-44
20-45
Advertisement
Table of Contents
