Clear Switch Member - Enterasys SecureStack B3 Configuration Manual

clear switch member

Example
This example shows how to specify a switch as unit 1 with a switch ID of 1:
B3(su)->set switch member 1 1
clear switch member
Use this command to remove a member entry from the stack.
Syntax
clear switch member unit
Parameters
unit
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to remove the switch 5 entry from the stack:
B3(su)->clear switch member 5
2-12 Configuring Switches in a Stack
Specifies the unit number of the switch.