Table of Contents
Advertisement
Table
6‐10 provides an explanation of the command output.
Table 6-10 show snmp notify Output Details
Output
Notify name
Notify Tag
Notify Type
Storage type
Row status
set snmp notify
Use this command to set the SNMP notify configuration. This creates an entry in the SNMP notify
table, which is used to select management targets who should receive notification messages. This
command's tag parameter can be used to bind each entry to a target address using the set snmp
targetaddr command ("set snmp targetaddr" on page 6‐26).
Syntax
set snmp notify notify tag tag [trap | inform] [volatile | nonvolatile]
Parameters
notify
tag tag
trap | inform
volatile |
nonvolatile
Defaults
If not specified, message type will be set to trap.
If not specified, storage type will be set to nonvolatile.
Mode
Switch command, read‐write.
Example
This example shows how to set an SNMP notify configuration with a notify name of "hello" and a
notify tag of "world". Notifications will be sent as trap messages and storage type will
automatically default to permanent:
B3(su)->set snmp notify hello tag world trap
What It Displays...
A unique identifier used to index the SNMP notify table.
Name of the entry in the SNMP notify table.
Type of notification: SNMPv1 or v2 trap or SNMPv3 InformRequest
message.
Whether access entry is stored in volatile, nonvolatile, or read-only
memory.
Status of this entry: active, notInService, or notReady.
Specifies an SNMP notify name.
Specifies an SNMP notify tag. This binds the notify name to the SNMP
target address table.
(Optional) Specifies SNMPv1 or v2 Trap messages (default) or SNMP v3
InformRequest messages.
(Optional) Specifies temporary (default), or permanent storage for SNMP
entries.
set snmp notify
SecureStack B3 Configuration Guide 6-31
Advertisement
Table of Contents
