Table of Contents
Advertisement
show gvrp
Purpose
To dynamically create VLANs across a switched network. The GVRP command set is used to
display GVRP configuration information, the current global GVRP state setting, individual port
settings (enable or disable) and timer settings. By default, GVRP is enabled globally on the device,
but disabled on all ports.
Commands
For information about...
show gvrp
show garp timer
set gvrp
clear gvrp
set garp timer
show gvrp
Use this command to display GVRP configuration information.
Syntax
show gvrp [port-string]
Parameters
port‐string
Defaults
If port‐string is not specified, GVRP configuration information will be displayed for all ports and
the device.
Mode
Switch command, read‐only.
Example
This example shows how to display GVRP status for the device and for fw.2.1:
B3(su)->show gvrp ge.2.1
Global GVRP status is enabled.
Port Number
-----------
ge.2.1
8-20 802.1Q VLAN Configuration
(Optional) Displays GVRP configuration information for specific port(s). For
a detailed description of possible port‐string values, refer to "Port String
Syntax Used in the CLI" on page 5‐1.
GVRP status
-----------
disabled
Refer to page...
8-20
8-21
8-22
8-22
8-23
Advertisement
Table of Contents
