set cos state
Use this command to enable or disable Class of Service.
Syntax
set cos state {enable | disable}
Parameters
enable | disable
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to enable Class of Service:
B3(rw)->set cos state enable
show cos state
Use this command to display the Class of Service enable state.
Syntax
show cos state
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to show the Class of Service enable state:
B3(rw)->show cos state
Class-of-Service application is enabled
clear cos state
Use this command to set CoS state back to its default setting of disabled.
Enables or disables Class of Service on the switch. Default state is
disabled.
SecureStack B3 Configuration Guide 10-19
set cos state