Clear Dhcp Pool Netbios-Name-Server; Set Dhcp Pool Netbios-Node-Type - Enterasys SecureStack B3 Configuration Manual

Syntax
set dhcp pool poolname netbios-name-server address [address2 ... address8]
Parameters
poolname
address
address2 ... address8
Defaults
None.
Mode
Switch command, read‐write.
Example
This example assigns a NetBIOS name server at 10.15.10.1 to the address pool being configured.
B3(rw)->set dhcp pool auto1 netbios-name-server 10.15.10.1

clear dhcp pool netbios-name-server

Use this command to remove the NetBIOS namer server list from the address pool being
configured.
clear dhcp pool poolname netbios-name-server
Parameters
poolname
Defaults
None.
Mode
Switch command, read‐write.
Example
This example removes the NetBIOS name server list from the address pool auto1.
B3(rw)->clear dhcp pool auto1 netbios-name-server

set dhcp pool netbios-node-type

Use this command to specify a NetBIOS node (server) type for the DHCP clients served by the
address pool being configured.
Specifies the name of the address pool. Pool names may be up to 31
characters in length.
Specifies the IP address of a NetBIOS name server.
(Optional) Specifies, in order of preference, up to 7 additional NetBIOS
name server addresses.
Specifies the name of the address pool. Pool names may be up to 31
characters in length.
clear dhcp pool netbios-name-server
SecureStack B3 Configuration Guide 15-25