Removing and installing front ABS
sensor
–
Remove right side section of fairing.
e
Caution:
Disconnect ground lead from battery and insulate.
•
Remove the left brake calliper.
3
•
Open cable ties securing ABS sensor cable (2).
•
Release ABS sensor cable (2) from clips (3) on
telescopic fork.
•
Disconnect plug (1).
L
Note:
Clean ABS sensor and bore before removing/install-
ing.
34.10
5
1
•
Release the fasteners (arrows) for ABS
sensor (5).
•
Take off ABS sensor (5) with spacing plate (4).
•
Installation is the reverse of the removal proce-
dure: pay particular attention to the following.
e
Caution:
Carefully route the ABS cable and secure in position
with cable ties.
•
Check/adjust ABS sensor gap.
Sensor gap......... 0.45...0.55 mm (0.018...0.022 in)
X
Tightening torque:
ABS sensor fasteners.................................... 4 Nm
2
Removing front ABS sensor ring
•
Remove front left brake disc.
X
Tightening torque:
Brake disc to front wheel
(clean thread + Loctite 243).......................... 21 Nm
KL340011
4
KR340040