BMW K 1200 LT 1999 Repair Manual page 143

Removing and installing pressure
regulator
– Remove left and right fairing side sections.
d
Warning:
Comply with safety precautions when handling or
working with fuel.
– Remove fuel tank.
....................................................See Group 16
a
•
Use hose clamps, BMW No. 13 3 010, to close
off fuel hoses at injection rail.
2
1
•
Pry out clip (1) at fuel injection rail.
•
Using pliers, remove pressure regulator (2).
•
Installation is the reverse of the removal proce-
dure: pay particular attention to the following.
L
Note:
Before installing, coat the sealing rings with clean
engine oil (silicone-free) or rub them with Vaseline.
13.8
Removing and installing throttle
valve rail
e
Caution:
Do not slacken the fasteners securing the throttle
valve stubs to the throttle valve rail.
– Remove left and right fairing side sections.
....................................................See Group 46
a
d
Warning:
Comply with safety precautions when handling or
working with fuel.
– Remove fuel tank.
....................................................See Group 16
a
– Remove left air outlet duct.
KR130130
•
Disconnect hose (arrow) from crankcase breath-
er.
•
Remove intake air silencer.
L
Note:
It is not necessary to disconnect the fuel hoses or
remove the cable ties from the fuel injection rail.
•
Remove fuel injection rail.
KR130260