BMW K 1200 LT 1999 Repair Manual page 144

4
3
•
Disconnect plug (4) for switch of cruise-control
system.
•
Disconnect the earth (ground) cable (3) from the
throttle valve rail.
•
Disconnect plug of throttle-valve
potentiometer (2).
•
Disconnect plug of throttle-valve actuator (1).
•
[Activated charcoal filter] Disconnect breather
hose to timing valve from y-piece.
•
Slacken screws securing hose clips at intake
stubs.
•
Remove throttle-valve rail from intake stubs.
7
e
Caution:
Do not remove retaining plate (6): the screws locate
the throttle valve stubs.
•
Disengage throttle-opener cable (7) from its pull
at the throttle valve rail.
1
2
KL130040
5
6
KL130050
8
6
•
Remove circlip (8).
•
Disengage throttle-closer cable (5) from its pull
at the throttle valve rail and remove throttle-clos-
er cable (5).
•
Disengage Bowden cable of cruise-control sys-
tem.
•
Installation is the reverse of the removal proce-
dure: pay particular attention to the following.
L
Note:
Note the installed positions of the hose-clamp
screws (arrows).
e
Caution:
After installing, check that Bowden-cable pulls at
throttle valve stubs move freely.
•
Check play of Bowden cables, adjust if neces-
sary
....................................................See Group 00
a
X
Tightening torques:
Fuel injection rail to cylinder head .................. 9 Nm
5
KL130030
KL130090
13.9