BMW K 1200 LT 1999 Repair Manual page 40

Installing the windscreen
•
Slightly raise the windscreen linkage.
•
Install windscreen and retaining plate (3).
•
Tighten the four screws (1) (micro-encapsulat-
ed).
L
Note:
It may be necessary to bend the inner clips (2) to en-
sure that the plate retains the windscreen properly.
Installing the windscreen cover
•
Clip the windscreen cover (2) from the outside
(arrow) inwards.
X
Tightening torques:
Windscreen to windscreen adjuster ............... 2 Nm
1
2
3
Checking and adjusting the
motorcycle
Checking the function of side stand
contact switch
•
Switch off the engine.
•
Place motorcycle on its centre stand.
•
Select a gear and switch on the ignition.
– Temperature gauge warning light lights up.
•
Extend the side stand, observing the tempera-
ture gauge warning lamp.
– Temperature gauge warning light goes out (en-
gine control unit switches off).
Adjusting the seat
•
Open the left-hand side case.
•
Open the seat.
•
Adjust the rider's position by means of the brack-
et.
Adjusting the top case
................................ See Installing the top case
a
KL460140
00.35