BMW K 1200 LT 1999 Repair Manual page 132

Replacing three-phase generator
Removing and installing three-phase
generator
L
Note:
It is not necessary to remove the gearshift linkage,
gearbox and clutch slave cylinder.
– Raise the frame.
...................................................See Group 23,
a
Removing gearbox
•
Remove the three securing screws (1).
•
Pull the three-phase generator off the inter-
mediate flange.
•
Installation is the reverse of the removal proce-
dure: pay particular attention to the following.
L
Note:
Apply tyre mounting paste or similar to the rubber
dampers; do not use oil or grease.
Use a hex socket with universal joint to tighten the
bottom securing screw (arrow), increase tightening
torque by approx. 10 %.
X
Tightening torque:
Generator to intermediate flange .................. 20 Nm
Screw for cable B+....................................... 10 Nm
Screw for cable D+......................................... 2 Nm
1
KL120010
Disassembling the three-phase
generator
Removing and installing drive housing
2
•
Take out rubber dampers (2).
3
12 4 600
•
Hold drive housing (4) with retaining device,
BMW No. 12 4 600, to prevent it from turning,
slacken screw (3) and remove it together with the
spring washer.
•
Remove the drive housing (4).
•
Installation is the reverse of the removal proce-
dure.
X
Tightening torques:
Drive housing ............................................... 50 Nm
Screw for cable B+....................................... 10 Nm
Screw for cable D+ ........................................ 2 Nm
2
KR120030
4
KR120120
12.11