BMW K 1200 LT 1999 Repair Manual page 119

1
Installing ignition pulse generator
•
Mount adjusting disc and rotor on crankshaft
and tighten.
•
Reinstall magnetic gate (1) in its original position,
as marked.
•
Tighten screws (arrows) with washers and semi-
circular washers.
X
Tightening torque:
Rotor .............................................................. 4 Nm
Magnetic gate ................................................ 6 Nm
e
Caution:
Set the ignition timing.
11.48
Installing ignition pulse generator cover
•
Run the wire to the ignition pulse generator
through a rubber grommet in the timing case co-
ver.
•
Secure the wires for the oil pressure telltale and
water pump temperature sensor with clip (2).
•
Install the cover with gasket.
X
Tightening torque:
Ignition pulse generator cover ........................ 9 Nm
2
KR110710