BMW K 1200 LT 1999 Repair Manual page 146

Removing and installing intake
stubs
•
Remove throttle valve rail.
•
Remove screws (arrows) and remove intake
stubs complete with sealing rings.
L
Note:
When installing the rear intake stub, do not forget
the clip for the fuel hose.
X
Tightening torque:
Intake stub to cylinder head ........................... 9 Nm
Replacing fuel hoses
•
Remove throttle valve rail.
•
Open the retaining clip (arrow).
1
•
Open clip (arrow) securing fuel-supply hose (1)
and fuel-return hose (2).
d
KR130090
Warning:
Comply with safety precautions when handling or
working with fuel.
•
Installation is the reverse of the removal proce-
dure: pay particular attention to the following.
2
e
Caution:
Make sure that the fuel-supply and fuel-return hoses
(1 and 2, respectively) and protective sleeve (arrow)
are routed correctly between the frame and the en-
gine.
•
Route fuel hoses such that coloured marks are at
the clips.
Coloured marks
KR130100
Blue ....................................................... Fuel return
White..................................................... Fuel supply
X
Tightening torque:
Retaining clip to engine.................................. 9 Nm
2
KR130080
1
KL130080
13.11