BMW K 1200 LT 1999 Repair Manual page 117

•
Press the guide rail (3) with timing chain and bus-
hing onto the locating pin.
•
Install the snap rings (1) and washers (2) for the
guide rail on the two locating pins.
•
Slip the chain onto the crankshaft gear.
7
9
•
Install the sprocket of the inlet camshaft such
that the timing chain is tensioned between the
sprocket and the crankshaft gear.
11.46
1
2
3
5
6
8
KL110040
•
Install screw (7) until seated.
•
Install guide rail (8).
•
Press the tensioning rail (4) onto the locating pin
and install washer (6) and keeper (5).
•
Install the sprocket of the exhaust camshaft such
that the timing chain is correctly tensioned bet-
ween the two sprockets.
•
Install screw (9) until seated.
•
Tighten the bearing caps with guide rail (8).
•
Remove the aligning device, BMW No. 11 3 700.
•
Tighten the chain sprockets, holding the hexa-
gon on the camshaft to prevent it from turning.
X
Tightening torque:
Bearing cap.................................................. 10 Nm
Chain sprockets ........................................... 56 Nm
4
KL110030