Removing and installing fairing side
section
•
Release 10 fasteners (2).
•
Pull pin (3) out of rubber grommet (4) in the bat-
tery cover.
•
Raise the fairing side section to disengage it from
the radio control unit.
•
Remove the fairing side section.
•
Installation is the reverse of the removal proce-
dure: pay particular attention to the following.
L
Note:
Loosely install all fairing screws before tightening.
46.10
•
Install securing screws (1).
L
Note:
When installing, note the position of the front corner
(arrow) of the fairing side section relative to the en-
gine spoiler.
•
[Right] Install 9 fasteners in clockwise direction.
3
4
•
[Left] Install 9 fasteners in counter-clockwise di-
rection.
X
Fairing screws ................................................ 2 Nm
KL460390
1
Tightening torques:
2
KL460010