Removing Gearbox Shafts; Replacing Grooved Ball Bearing On Intermediate Shaft - BMW K 1200 LT 1999 Repair Manual

3
80...100 h

Removing gearbox shafts

•
Heat bearing points in gearbox cover to
80 °C ... 100 °C (176 °F ... 212 °F).
•
Remove input shaft (2), output shaft (3) and inter-
mediate shaft (1) from the cover together.
Replacing grooved ball bearing on
intermediate shaft
e
Caution:
Apart from the grooved ball bearings, the intermedi-
ate shaft must always be replaced as a complete
unit.
If the grooved ball bearings are replaced, the fully
assembled length must be re-adjusted.
23.18
00 7 500
•
Pull off the grooved ball bearings with a universal
puller, BMW No. 00 7 500.
•
Press the output-side grooved ball bearing on to
the intermediate shaft.
– Checking/adjusting fully assembled length of in-
termediate shaft
......................................................... See below
a
•
Place spacing washer of calculated thickness in
position and press on the input-side grooved ball
bearing.
1
2
KL230300
KR230070