Removing And Installing Front Abs Sensor; Adjusting Play At Piston Thrust Rod - BMW F 650 GS Repair Manual

Adjusting play at piston thrust rod

2
1
•
Insert feeler gauge (1) 0.2 mm (0.008 in) thick be-
tween the lug of the brake pedal and the stop on
the frame (arrow).
•
Slacken nut (2) on the thrust rod at the brake
master cylinder.
•
Turn piston rod (3) clockwise to obtain play.
•
Carefully back off piston rod to take up play and
tighten locknut.
•
Tighten the locknut on the piston rod and remove
the feeler gauge.
X
Tightening torques:
Locknut .......................................................... 9 Nm
34.14
34 52 044
front ABS sensor
–
3
–
–
E340260
•
•
•
•
•
•
•
–
X
Front ABS sensor........................................... 9 Nm
Removing and installing
Place the motorcycle on its main (centre) stand.
Remove seat.
Remove left cover ( 46.5).
a
4
Remove the fastener securing ABS sensor (4) to
the front fork.
5
Disconnect ABS plug (5).
Press ABS plug (6) to the rear and out of its holder.
Cut the cable ties on the brake hose and the in-
strument carrier.
Remove the sensor cable from the holder on the
front fork.
Remove the sensor and the cable.
Installation is the reverse of the removal procedure.
Check gap of ABS sensor and adjust if neces-
sary ( 34.20)
a
Tightening torques:
E340150
6
E340160