Installing Gearbox Housing - BMW K 1200 LT 1999 Repair Manual

23 4 732

Installing gearbox housing

•
Install pin (arrow) in cover.
e
Caution:
Clean and de-grease the sealing faces.
The sealing compound sets within 30 minutes; with-
in this time, place the housing in position and tighten
the securing screws.
•
Using the metering device, apply Loctite 574
surface sealant to the mating face of the cover.
•
Place assembly sleeve, BMW No. 23 4 732, on
the output shaft.
•
Place assembly sleeve, BMW No. 23 4 712, on
the input shaft.
•
Place assembly sleeve, BMW No. 23 4 612, on
the selector shaft.
23 4 700
•
Heat the bearing seats in the housing to
80 ... 100 °C (176 ... 212 °F) and place the hous-
ing on the cover.
•
Install securing screws in gearbox housing and
tighten in diagonally opposite sequence.
X
Tightening torque:
Housing cover to housing .............................. 9 Nm
23 4 712
23 4 612
KL230310
h
80...100
KL230101
23.31